Activity Stream

Just nice to know there's life out there somewhere-----my son Mark came across Jimbo a few years back when he was teaching a youngster how to go...

John Rinker, brother Jerry still races Tri Hulls at 73 year old, Dick O'Dea...Me, Fred Hauenstein is still racing. Jimbo and Cathy are living in...

too much smoking the green stuff. but if it keeps you happy then carry on, it dont hurt anyone.

That boat is not doing 45-50 filthy, I'm sure it's doing what modified said. No small race boat in your area that you can buy filthy? Trust me when I...

Hells teeth Ron------dead lice are dropping of the site-------is there anyone left alive out there? I read that a couple of the old farts cashed in,...

was there a printed logo/name and if so what does it look like or what letter font used

thanks for the help

Hal varied them, small for side hydro coaming, large for deck or side of the runabout. He would supply 2 sizes when you bought a set of plans as I...

Does anyone have overall dimensions?

The white part of the bird is medium orange with black trim and details and the boat is black

still looking for a Delta even if it needs resto work.

On that prop it has positive rake because it tilts to the rear. Positive rake angle is the rearward tilt off the vertical from the prop shaft hub...

My late (and damn good buddy) ran a 400 inch SB Chevy on methanol, using a huge Holley 4 barrel. I was stunned by the size of the jets that thing...

Is there way to measure prop rake? What kind if props you are using with runabouts?

AH the joys of running alcohol. Back in the 80`s we ran it in out V-6 OMC and it made a lot of power over gasoline. Cleanout was a bitch tho. We...

I am also looking for the correct colors for the hal kelly logo if it not black and white

Post pics, how long, bottom width, afterplane length?

The linkage has to be wrong, maybe the plastic behind where the cables run. I would take the whole lot of then start a fresh. look at the diagram...

I can not find a difference with our Merc 15 (2000). Only grease, a lot of thick grease. I use a little teflon lubricant.

I have 2 of these motors in the shop now, one is an early version with a round tube tiller arm, the other is like yours with a tiller arm that's a...

you dont need pressure so much, you need volume. any pressure from about 2 to 5 is plenty of pressure for our type of carburettors, its just a good...

its amazing sometimes how fast little mini boats look when doing around the 45 to 50mph speed. anything over 40 in a mini boat is pretty fast...

go to https://www.youtube.com/watch?v=gnqr7C2jcuY One of my modified 45ss Engines on mini deep vee in Saint Thomas............ Best Pass of Day...

bump, open to offers!

I've got another one of these, after £299 + postage for it, in very good condition

The 1" venturi 2bbls will light up a stock OMC 50 Twin. Getting on plane isn't that bad with a light boat. Only thing I never did was rig a...