Vacturi 500 jets

[niesenracing]

Can anyone tell me the size of the supply holes jets? I a set with 1/16,
one with 3/32 and one with 1/16 holes and cut at 45 degrees

[racnbns]

Can anyone tell me the size of the supply holes jets? I a set with 1/16,
one with 3/32 and one with 1/16 holes and cut at 45 degrees

I checked 2 carbs and a loose set and here's what I found.

1. Jets from new carb. Jet has screwdriver slot for removal, straight cut at bottom and .054 holes. I think this was a gas carb for a P-500 pump.

2. Jets from modified alky carb. Jet has 5/8 hex for removal, angle cut on bottom and .076 holes.

3. Loose jets with tag marked alcohol. These jets have 5/8 hex, straight cut on bottom and .061 holes. I think the jets in my 4-60 are the same as these.

Thats all I know,
Bruce

[niesenracing]

thanks for the information. See you at DePue.