Ahhh, a real pattern maker!
[QUOTE=R Austin;124991]Tim
You should have told me you needed a filler block. I have 3 left that I patterned up and made to complete one of my deflecters.A small trim job on each end and bottom slides thru exhaust drop outlet and swings down in. Fits like a glove. Shrinkage rate is 1/64 inch per inch.
Hey Dick,
At the time, I didn't know there was a problem with the casting in hand. Sure wish I knew before, your casting would have saved hours and $25 Heliarc..... Thanks for the casting knowledge: 1/64" shrink/inch (.0156") makes more sense as the 18" filler block X .0156" = .281" shrink. Will make due with this for now, but would like one for a backup. Please bring to Suter's.
Tim