For all of you Mod-50 fanciers... I loaned Phil McDaniel a brand new sleeve for duplication. Contact him for replacements.
Tim
Printable View
For all of you Mod-50 fanciers... I loaned Phil McDaniel a brand new sleeve for duplication. Contact him for replacements.
Tim
ya thinkin i'll do somethin with that case:cool:
got that fuel system hooked up, what size drill bit, 1/16th, for the return line jet? gettin some pics :cool:
it says (.060 orifice), theres a .060 jet in the return line. it forces the fuel to the carb side, i made that setup in the schematic, tapped out the return line elbow
for a 5/16ths set screw, drilled the set screw with a 1/16th drill bit. got pics but not till sunday:eek:
thanks fred. do you think a holly red 5 psi fuel pump work on this setup?
thinkin 3 psi for the 1 bbl carbs:eek:, Holly makes a 1-5psi regulator, just and it in line after the pump.:cool:
I run two jets as on the return side i have the choke line going off it.
A 52 jet after the carbs.. 60 at the T where the choke comes off to get flow to the choke.
I run a the holley reg too. 3.5 psi is where its at.
so ive added a pyro meter in the exhaust meg right at the top.
any ideas on exhaust temp should be?
i got 985 deg f, at 8000rpms:cool: