reed mod's

I'm lookin to do some reed mod's on omc 3 cylinder reed cages. I've heard of opening them up. what kind of modifications can anyone tell me about. thanks

What kind of motor do you have

Really the restrictions just need to be removed and add a set of aftermarket reed pedals

when you say "restrictions " what exactly do you mean ?
are you talking of just flash marks or is there any other things that need doing. i know not to polish the area too much

not just the flash, I would remove the overlap between the reed pedals on the block

when you say overlap, do you mean the edges by the reeds where it sort of curls a bit ?
if not any pic you have of this would help.
I have a spare set of reeds and the complete intake housing that I am just about to delve into myself.
I did flatten the blocks down a touch a while back due to noticing they were no where near what I call level finish.
I just put a sheet of wet n dry on a dead flat surface and used elbow grease to get them as level as they will ever be.

over the coming week I will be doing a lot of cleaning up flash marks on several parts of the motor, so while at it I will have a good butchers at the intake again.

Phill you working on a triple or twin

triple Evinrude 56 cu in 1995 oval port model..