Search:

Type: Posts; User: whaledog; Keyword(s):

Search: Search took 0.00 seconds.

  1. Thread: tach question

    by whaledog
    Replies
    2
    Views
    2,423

    OB tachs

    Stator driven tach is usually 12 pole some early V6 were 10 pole.
  2. Replies
    17
    Views
    7,864

    hook

    Check for hook in bottom strakes and pads.most manufactures put hook in the back of the boat to help get on a plane.if it is filled in removed it is a faster bottom.when removed the boat will stand...
  3. Thread: water tube

    by whaledog
    Replies
    1
    Views
    2,493

    tube

    pulled mine out of a spare midsection 200HP measures 18 7/8" inches.
  4. Replies
    31
    Views
    12,795

    brp.com

    http://www.intercoastalmarinemd.com/
    looks like a good dealer in your area .I started as a one man shop myself years ago .honest mechanics people always do good if they work hard at what they do...
  5. Replies
    31
    Views
    12,795

    voltage

    You need a peak reading volt meter and a service manual to check your ignition circuits.you have quick start on that engine .to check power pack output you also need adapters PL88.is the power pack...
  6. Thread: 9.9

    by whaledog
    Replies
    27
    Views
    8,594

    15 carb

    with a 15 hp carburator the 15 motor turns 6,000 rpm rated.
    the 9.9 hp motor is restricted by the carburator size turns only 5,000 rpm.
    this is a factory stock rated rpm for horsepower.If you...
  7. Replies
    4
    Views
    3,520

    starvation

    Check fuel starvation ,restriction in fuel pickup.use clear vinyl hose to check for air leaks(bubbles in fuel supply line)install fuel line T and install vacume gauge.run engine full throttle with...
  8. Replies
    9
    Views
    7,550

    salty

    I started my outboard career in a salty enviroment.Merc power heads would have drive shafts rusted in the crankshaft.I would have to cut the shafts to remove power head.
  9. Replies
    103
    Views
    42,870

    cooling

    Trim tab has a cooling water pickup to cool the prop hub in later production engines.
  10. Replies
    7
    Views
    4,693

    surface gap plugs

    UL77V plugs are cold running at low speed.If you can get the RPM out of the engine with those plugs good or try something else.
  11. Replies
    7
    Views
    4,693

    starters

    Need a good starter for sure battery cables should be in good shape and size.Some engines had wrong battery cables 6 gauge came on smaller engines.Should have 4 gauge or bigger wire and solder on...
  12. Replies
    7
    Views
    4,693

    Jets

    We ran 73c to 76c main jets in our V4s .Jets are in float bowl sides need omc speacial jet remover tool to change jets .We ran 185 psi compression with 24 degrees timing.We ran champion gold paladium...
  13. Replies
    19
    Views
    9,661

    manuals

    all manuals avaliable from www.kencook.com/evinrudejohnsonmanuals/index.cfm?fuseaction=home.main - 8k]
    publishers of omc manuals.
  14. Replies
    18
    Views
    6,527

    merc exhaust covers

    merc side covers exhaust plates gaskets will leak if you over tighten them.
    the gaskets split easily all will spray into the exhaust ports.
    torque exhaust covers to spec 150 inch pounds , not to...
  15. Replies
    66
    Views
    35,292

    nitro

    what is a nitro gearcase .I have a small hub gearcase 50 short.
    Nose cone for this avaliable from?
Results 1 to 15 of 16