this gearcase does not have through hub exhaust
Type: Posts; User: gotboostedvr6; Keyword(s):
this gearcase does not have through hub exhaust
I have a late 70's 25 hp tiller and am in the process of a complete rebuild... I'm 90% done but while i was replacing the WP the drive shaft slid out there are no clips or pins that hold it in so i...
see this thread for more info, i hope you guys went over the core....
http://forums.screamandfly.com/forums/showthread.php?t=100162
someone want to help me find a good 60 block or complete powerhead ? :)
ok they look the same so here is my plan.
The electric PH is off here is a pic of the base w/o the exhaust tuner installed...
http://i24.photobucket.com/albums/c24/gotboostedvr6/50hpEbasepic.jpg...
also are these loopers or crossflows?
I picked up a 71 50 hp electric will the powerhead bolt up if i use the 87 48 front half?
is the 60 hp you are referring to a commerical ?
I have a 81 35 hp PH and a 8748 hp complete motor with low compression.
# 1 Will the powerheads interchange?
# 2 Are the bore sizes the same?
# 3 Will the 48 hp front half fit the 35 hp...
The first cut or slow down is abrupt. it goes from 5500 rpm down to 4600 or so than down to 3300. The fuel bulb stays firm never softens up
Ill slow to craw for 15 to 20 sec then run it back up...
So far I've rebuilt the carbs, replaced the vro pump Found a bad coil and replaced it ..... so far it seems that the fuel problems fixed, motor runs like champ but only for about 2 min till it starts...
I have a 85 VRO 175 Crossflow on my Proline W/A.
The first time i started it the thermostats were both clogged so i removed them. I have replacements on the way. Temp problem fixed.
Next...