I have a 1236 flat bottom with a 25hp Mercury turning a 15 pitch Powertech SRA3. I originally had the jackplate set as shown in the third picture. I was turning 6000 rpm and hit 39mph. I raised the...
Type: Posts; User: abwehrly42; Keyword(s):
I have a 1236 flat bottom with a 25hp Mercury turning a 15 pitch Powertech SRA3. I originally had the jackplate set as shown in the third picture. I was turning 6000 rpm and hit 39mph. I raised the...
Is it possible to add a water pressure gauge to a Suzuki dt25c? I am running with the bottom of the water pickups even with the bottom of the boat and hoping to go higher.
I have a 1988 two stroke 70hp Yamaha, with the 2.33:1 lower unit. I would like to run a smaller lower unit with higher gears.
I know that the lower unit from a 55hp Yamaha will bolt up, and has a...
Can I have an SRX chopper rehubbed to run on a 70/90 Yamaha gearcase?
Keep looking for actual 70hp carbs. The throat is 1/4" bigger.
Sigma Switch 112F, I got the clear cover to go over it too.
The switch fits well:
http://i187.photobucket.com/albums/x183/Cubman1944/2012-12-14_17-53-51_928.jpg
That's an idea. Are you saying come far enough out so your fingers go between the bracket and the twist grip? I'd hate to hit a stump with my fingers trapped in there like that though.
How do I get the wires past the throttle cable? From what I can see, the cable takes up the entire interior of the handle.
Alright, I got the handle apart thanks to your guidance Fast Fred. It looks like there won't be any room for wires to run through the middle where the throttle cable is.
I would like to set this...
Thank you for the advice Fast Fred. I will give that a try next weekend. I got a little round rocker switch to put on the end IF there is room to run wires through the handle.
I don't have any...
I am trying to mount a trim switch on the end of the idle adjustment knob of a OMC V4 tiller handle. Can anyone explain how to disassemble the twist grip end of this tiller handle? I have the roll...
My 3cyl johnson had a threaded hole right by the top spark plug hole, made for a temp sender.