Search:

Type: Posts; User: ToneDef; Keyword(s):

Search: Search took 0.00 seconds.

  1. Replies
    12
    Views
    14,290

    Rigged the steering up direct today using 1/4" SS...

    Rigged the steering up direct today using 1/4" SS flat bar for a motor bar. Even though the hub is very small (it's an old helm I had laying around) it still steers with more response and in a...
  2. Replies
    12
    Views
    14,290

    The hub is small, apprx. 3.5" in diameter. I will...

    The hub is small, apprx. 3.5" in diameter. I will try direct first because I would like to keep the wheel turn per boat turn to a minimum. Plus, I can always just replace the cable if I don't like it!
  3. Replies
    12
    Views
    14,290

    Steering cable setup

    I'm in the process of setting up cable pulley steering and had a question.

    Are the two additional pulleys on the motor bar really necessary? I understand it makes the steering easier, but it would...
  4. Replies
    7
    Views
    6,120

    Caterpiller Anerobic Gasket Maker. For some...

    Caterpiller Anerobic Gasket Maker. For some reason I always seem to have like 8 tubes of it laying around, so I use it. Same stuff as Yamabond more or less.
  5. Thread: turn fin

    by ToneDef
    Replies
    4
    Views
    3,007

    If you have a very shallow vee in the rear, the...

    If you have a very shallow vee in the rear, the fin may be in contact with the water regardless of your turning situation. My 8' is a monohull, and as per the building instructions I've got a single...
  6. Thread: Cylinder Hones

    by ToneDef
    Replies
    10
    Views
    6,470

    here is what I use for my 2 strokes; one of this...

    here is what I use for my 2 strokes; one of this style.

    http://toolmonger.com/wp-content/uploads/2009/04/hone.jpg
Results 1 to 6 of 32