Search:

Type: Posts; User: abwehrly42; Keyword(s):

Search: Search took 0.00 seconds.

  1. Replies
    4
    Views
    15,864

    12ft Flat Bottom Setup

    I have a 1236 flat bottom with a 25hp Mercury turning a 15 pitch Powertech SRA3. I originally had the jackplate set as shown in the third picture. I was turning 6000 rpm and hit 39mph. I raised the...
  2. Replies
    0
    Views
    1,969

    Suzuki Water Pressure

    Is it possible to add a water pressure gauge to a Suzuki dt25c? I am running with the bottom of the water pickups even with the bottom of the boat and hoping to go higher.
  3. Replies
    9
    Views
    15,340

    70 Yamaha - Smaller Lower Unit

    I have a 1988 two stroke 70hp Yamaha, with the 2.33:1 lower unit. I would like to run a smaller lower unit with higher gears.

    I know that the lower unit from a 55hp Yamaha will bolt up, and has a...
  4. Replies
    0
    Views
    1,906

    SRX on a Yamaha

    Can I have an SRX chopper rehubbed to run on a 70/90 Yamaha gearcase?
  5. Replies
    2
    Views
    1,615

    Keep looking for actual 70hp carbs. The throat is...

    Keep looking for actual 70hp carbs. The throat is 1/4" bigger.
  6. Replies
    13
    Views
    6,705

    Sigma Switch 112F, I got the clear cover to go...

    Sigma Switch 112F, I got the clear cover to go over it too.
  7. Replies
    13
    Views
    6,705

    The switch fits well:...

    The switch fits well:
    http://i187.photobucket.com/albums/x183/Cubman1944/2012-12-14_17-53-51_928.jpg
  8. Replies
    13
    Views
    6,705

    That's an idea. Are you saying come far enough...

    That's an idea. Are you saying come far enough out so your fingers go between the bracket and the twist grip? I'd hate to hit a stump with my fingers trapped in there like that though.
  9. Replies
    13
    Views
    6,705

    How do I get the wires past the throttle cable?...

    How do I get the wires past the throttle cable? From what I can see, the cable takes up the entire interior of the handle.
  10. Replies
    13
    Views
    6,705

    Alright, I got the handle apart thanks to your...

    Alright, I got the handle apart thanks to your guidance Fast Fred. It looks like there won't be any room for wires to run through the middle where the throttle cable is.

    I would like to set this...
  11. Replies
    13
    Views
    6,705

    Thank you for the advice Fast Fred. I will give...

    Thank you for the advice Fast Fred. I will give that a try next weekend. I got a little round rocker switch to put on the end IF there is room to run wires through the handle.

    I don't have any...
  12. Replies
    13
    Views
    6,705

    OMC V4 Tiller Handle

    I am trying to mount a trim switch on the end of the idle adjustment knob of a OMC V4 tiller handle. Can anyone explain how to disassemble the twist grip end of this tiller handle? I have the roll...
  13. Replies
    2
    Views
    2,768

    My 3cyl johnson had a threaded hole right by the...

    My 3cyl johnson had a threaded hole right by the top spark plug hole, made for a temp sender.
Results 1 to 13 of 13