I run the up on the floor and down on the wheel.
Learned it from Bob Herring years ago.
I use the large metal waterproof push buttons with rubber covers over them.
I like having the multiple...
Type: Posts; User: sst45jefff; Keyword(s):
I run the up on the floor and down on the wheel.
Learned it from Bob Herring years ago.
I use the large metal waterproof push buttons with rubber covers over them.
I like having the multiple...
Got it figured out.
Everything running great now.
I am very familiar with working on SST45 motors but not the newer motors with VRO pumps & this has me stumped.
I bought this boat this winter. It was sitting outside in the pacific northwest &...
This is how I break sst45 motors in & I have never burnt one up breaking it in.
We get good a good ring seat with this procedure & I generally take them out & race them after this break in...
The same one Scott mentioned- the commercial one.
And there has been no problem reading it.
http://tinytach.com/tinytach/index.php
Tiny Tach several guys use these and we use one. they are inexpensive.
The original OMC tachs are no longer available that use the tach wire off of the...
hook the one side of your kill switch to the same spot on the terminal block as the power pack kill wire.
This is a typical hook up spot for easy replacement of the power pack.
black wire with yellow stripe coming out of the power pack goes to one side of the switch and the other side of the switch gets grounded to the motor usually on the screw that holds the wire...
wrong year, everything in it is different than the sst45 motors.
you want the years around 1987-88-89
If it has been dunked in the saltwater and was not dried out properly, it is completely junk.
Seems there is only one fuel from the VP list you linked that is not oxygenated.
What about the logistics for the rest of the race programs across the country to get legal fuel. It is a huge...
It was about $350.00 to do the three axles on our trailer.
They heated them up and straightened them all out. I was surprised at how inexpensive it was to do considering what they were doing.
I...
I would check the alignment on the axle ends. (The torsion spring ends with the axle.
It seems like that is the wear pattern are trailer was having when it was wearing tires out very quickly (20,000...
probably the wrong pulse setting or the wrong tach for the year motor you have.
Yes - at the dealer.
probably wont help you though unless there is a ton of humidity and it was not jetted right for the area to begin with.
do you mean the signature picture on the left of each post?
If so you upload it under your control panel. the info is there on hoew to do it.
Yes the water pump can push water past the seal into the gearcase. One of the symptoms is the gearcase being presurized.
Sound like you need to change the seals below the water pump.
check to see if it sheared the flywheel key and spun the flywheel. Your timing would be off if the flywheel has moved even a litttle bit.
try your local starter /alternator repair/rebuild shop for new brushes. they are easy to put in. just take the old one with you to match it. my last set cost $10.00.
if you need a new trim motor...
Congrats guys, It is great when everything comes togethere.
Grand Prix Boats is built by Bruce Buorquin in the Sacramento, California area.
I dont know that he has the molds still for the older Grand Prixs. Some of the newer boats may be the same, you would...