Want To Retrofit Power Trim To A 15" Johnson 75 Stinger HELP PLEASE

[moomba]

I need help with adding power trim on a 75 HP Johnson Stinger with 15" Mid. Has anyone done this and what do I need to do it???? Help PLEASE 603-568-4166

[Powerabout]

The SST 60 parts fit.
You need to contact Seaway Marine in Seattle
http://www.sea-way.com/

[moomba]

The SST 60 parts fit.
You need to contact Seaway Marine in Seattle
http://www.sea-way.com/

I called them and they said they didn't have anything. Any more ideas.
Thanks
Steve

[Powerabout]

I am working on an late model fastrak trim version with an exhaust housing cut down with solid mounts to create a 15"
It will need wing bar steering
I wont have a product for a few months so no help until then

[moomba]

I am working on an late model fastrak trim version with an exhaust housing cut down with solid mounts to create a 15"
It will need wing bar steering
I wont have a product for a few months so no help until then

I was hoping to find something with the steering in the tilt tube so I can use NFB rack steering.

Keep me posted

[michael]

I have done it, see my posts here
http://forums.fiberglassics.com/g3/
Posts done on July 22, with most posts labelled yamarude. Start at bottom and work up

[Detroit Whitey]

Just use the clamp ears and pivot tube off of a1990or newer 2cly jhonson use your pivot arm and bottom mount clamp off the stinger then you can use the thru tube steering and the new eTech trim will fit.you will want to buy the soild lower mounts from sea-way the sst60 ones are the ones you want but you dont need them.This hole set up can be bought new and the part numbers are out there. No need to junk up a jhonson with yham parts

[moomba]

I have done it, see my posts here
http://forums.fiberglassics.com/g3/
Posts done on July 22, with most posts labelled yamarude. Start at bottom and work up

Thanks that is what I was looking for. If you see a good used Yami trim let me know.
Thanks
Steve

[moomba]

Just use the clamp ears and pivot tube off of a1990or newer 2cly jhonson use your pivot arm and bottom mount clamp off the stinger then you can use the thru tube steering and the new eTech trim will fit.you will want to buy the soild lower mounts from sea-way the sst60 ones are the ones you want but you dont need them.This hole set up can be bought new and the part numbers are out there. No need to junk up a jhonson with yham parts

If someone has the part numbers let me know. Again thanks for the info.
Steve

[Powerabout]

I have done it, see my posts here
http://forums.fiberglassics.com/g3/
Posts done on July 22, with most posts labelled yamarude. Start at bottom and work up

Nice job!
FF has a few photos on his thread as well