new SMACK project

[orangebeast]

we run wooden boats that are just pieced together with a lil glue and a few nails, cant afford anything else. oh i got another rig i am workin on. ill get some pics up very quick.

[Craig Wayne]

Boat is a Custom Camo Viper,

Basically a Critchfield 13ft v w/ no deck.

Motor is 45 cubes, std 1bl carbs, 2 bls on bench, medium port work, BIG EXPANSION CHAMBER.

Havent run yet, hope to have in water in April.

hoping for 60 ish

will post some more pics later tonight, can't find my **$%*& camera.

Thats a good looking boat !!!

[YAMAHAFASTCRAFT]

hope everything goes well.that the first viper i seen with a 2 cylinder onit.

[OUTBOARDER]

Boat is a Custom Camo Viper,

Basically a Critchfield 13ft v w/ no deck.

Motor is 45 cubes, std 1bl carbs, 2 bls on bench, medium port work, BIG EXPANSION CHAMBER.

Havent run yet, hope to have in water in April.

hoping for 60 ish

will post some more pics later tonight, can't find my **$%*& camera.

I want to drive the Red Car in the Garage!

[thornl01]

After quite a few unsatisfactory trips to the river, Finally got the engine & carbs partially sorted out. Had things too FAT, jet wise, Just being too conservative i guess.

Best run so far, 66.7 mph by gps @ 7200 rpm, Think it's got some more to go.

Learing to tune an engine w/ an expansion chamber is a different animal.

[OUTBOARDER]

After quite a few unsatisfactory trips to the river, Finally got the engine & carbs partially sorted out. Had things too FAT, jet wise, Just being too conservative i guess.

Best run so far, 66.7 mph by gps @ 7200 rpm, Think it's got some more to go.

Learing to tune an engine w/ an expansion chamber is a different animal.

Hello Lawerance,
you are up against the pipe for now and think its time to shift gears!
Finally going to the shop again and will get you some stuff to test.
Hope to see some video soon!