Thanks Thanks:  0
Likes Likes:  0
Results 1 to 10 of 92

Thread: Fitting low water pick up to outboard engine

Threaded View

  1. #21
    phillnjack
    Guest

    Default

    you must have a different gear ratio to me. My engine has a 2.42 gear ratio i think !!!!
    if my engine did 7,000 rpm with a 24 inch prop with zero slip it would only run 65.7mph
    But mine im sure is limited to 6,000 revs, so that prop (if my engine could swing it)would
    give 56.34 mph with zero slip !!!!!!

    i realy dont have any low end torque problems with this engine, its like power all the way through.
    But ofcourse ive not tried to swing a bigger prop than the 19 sst that ive got on there at the moment.

    phill...........
    Last edited by phillnjack; 01-13-2013 at 04:58 PM. Reason: wrong numbers

Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

Similar Threads

  1. Low water pick up Nose cone for 50hp
    By gtf1 in forum Technical Discussion
    Replies: 20
    Last Post: 07-01-2014, 01:08 AM
  2. mercury low water pick-up nose cone
    By Arkansas river rat in forum Technical Discussion
    Replies: 2
    Last Post: 01-23-2011, 08:07 PM
  3. Low water pick up
    By looseunit225 in forum Technical Discussion
    Replies: 2
    Last Post: 01-17-2009, 10:17 PM

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •