Will a suzuki dt75 prop fit a evinrude 3 cylinder ?????

[phillnjack]

my engine is the evinrude 60hp 56cu in engine,with the normal gearbox, not race box.

ive seen a prop advertised that says
It has 3 stainless steel blades and a 13 tooth spline.
13 x 21 the prop is a VS2100 part no 58100-94571.
Suitable for Suzuki models: DF60/70 1998-2009 DT60/ 70 / 75 / 85 / 90 / 100 / 115 / 140 1986-2000 .

would this be the same size gearbox as my evinrude engine ?
im pretty sure mine is 4 inch hub but dont know the size of suzuki gearbox of say the DT75 .

if this would fit then i can buy at a good price and give it a try.



phill.......

[phillnjack]

come on guys
surely somebody knows if this will fit ?
i can get a deal on this prop if it does fit, but dont want to spend my prop money and find it wont go on.
ive been told by the guy who has it that the hub piece that goes into the gearbox is aprox 3 3/4.

i realy need a definitive yes or no on this one. or if i can simply shave a bit off the prop hub etc to
make it fit.
I cannot find any info on the suzuki spline apart from its 13 splines.
i dont know the diameter even of the shaft !!!!!!!

somebody must of tried a suzy prop on an omc at some time or other.

please let me know


phill

[propfxro84]

Yes it will fit, you will have to fab a thrust washer and a washer for the nut end, though. What pitch and diamater are you looking for? I have tons of that stuff in stock. (Not any over hub or cleavers though). Bryan

[propfxro84]

BTW what is a "good" price? If I have that prop in inventory you can have it for less than $100. I do have a "like new" 22 raker for $175 or a brand new 23 renegade 4 blade for $175. Let me know what you want. Bryan

[phillnjack]

pm sent to you Bryan