56er six pack build

[Fast Fred]

the early 75hp had a cast crank, and skinny rods, some liked that setup best, said it pulled better. is lookin like she needs a buff.

[Per]

Think I Will be able to sort the rust on the taper with electrolytic rust removal and a buff. Just want to make sure I could use it before I put any work into it. Thanks for the heads up!

[75luva]

doin research, talked to some dudes down under, see what they are runnin, lookin for long rod pistons on this planet, none. chuckin out cranks lookin for a nice one. did find some one to machine finger ports and fit new pistons, sorting through what makes HP,and what does not. it's out to be machined in about a week...................

Hey fred i got a set of new long rods and mod50 pistons off tim kurcz unsure if he has any more forsale
Im building a mod myself just waiting on adaptor plate which is being made.

[Fast Fred]

got 4 sets on the shelf,runnin a set in my 19s, i had them top pinned and moved the ring gap out of the finger port. lookin for a set of long rod 56er pistons.heard about a set of 56er long rod pistons tested at the factory.

[sharpeye Mike]

Fred do you know the length of the tuner on the SST60? I seem to get two different measurements from my research, one is 7 5/8" from bottom of power head the other is from the bottom of the adapter plate. From the bottom of the adapter seems long according to the pics. I seen of it.
By the way how did the tuner that you modified with the aluminum base ball bat work out for you?

[Powerabout]

the measurement will be on the APBA rules site

[oledawg]

7.69" from the powerhead mating surface to the end of the tuner.

[sharpeye Mike]

Perfect, thanks a lot guys , working on my short shaft 56 project and I'm at that stage, now I can move on.
Thanks again

[Fast Fred]

bump

[Fast Fred]

tryin to get a clip up of a Fast Fred SST60 with 31m port map............... so far not workin for me