Thanks Thanks:  0
Likes Likes:  0
Results 1 to 2 of 2

Thread: how to remove oil ijection gear on 60 merc?

  1. #1
    Team Member fs5's Avatar
    Join Date
    Jun 2008
    Posts
    208
    Post Thanks / Like

    Default how to remove oil ijection gear on 60 merc?

    Hi , I want to remove the oil injection gear from a 59ci 60 merc. Dose anyone know how to remove them .
    Thanks

  2. #2
    Team Member
    Join Date
    Dec 2004
    Location
    Lake Lanier (North of Atlanta, Georgia)
    Posts
    54
    Post Thanks / Like

    Default

    1. remove the linkage to the oil pump.
    2. remove the oil pump and pull out the pump driveshaft (it kind of "unscrews" as you pull it out).
    3. reinstall the pump with only the o-ring seal in place (you're plugging the hole with a disabled pump)
    4. replace the length of fuel line where the oil line tees in with a straight piece of fuel line (I use yellow Tygon everywhere).
    5. take off the oil warning module and tuck away any excess wiring (except tan wire).
    6. connect the tan wire from cylinder head temp switch to the engine harness tan wire so you still have an overheat alarm.
    7. You can leave the tank or remove it... For drag race, you "COULD" convert it to a gas tank!??

Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

Similar Threads

  1. 850xs gear case into 1500xs gear case project
    By milkdud in forum Technical Discussion
    Replies: 3
    Last Post: 04-24-2014, 06:19 AM
  2. gear ratios merc 90hp
    By bobvdinghyracer in forum Technical Discussion
    Replies: 5
    Last Post: 03-28-2011, 08:16 PM
  3. remove exhaust guide on 25hp yamaha?
    By biggdave92 in forum Technical Discussion
    Replies: 4
    Last Post: 01-09-2010, 06:49 AM

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •