Page 2 of 2 FirstFirst 12
Results 11 to 13 of 13

Thread: Gearcase Blueprinting

  1. #11
    Administrator Ron Hill's Avatar
    Join Date
    Nov 2004
    Location
    Tustin, California
    Posts
    8,343
    Post Thanks / Like

    Default Shimming is Correctly is Best

    Quote Originally Posted by Roflhat View Post
    Alright, I've never tried shimming the gearbox but heard you can shim it tighter to gain some rpm. Not sure if there's much to be gained by balancing the gears seen as the diameter is relatively small but any gain is of course welcome
    Did you do any back to back tests with the different gear oils? I looked into it a while back and it looked like Amsoil 75w90 or Castrol hypoy 80w90 looked like decent candidates
    Shimming it looser, may increase your RPM til it blows up. Raise the motor 1" and get a new propeller. This will do more than all the blue printing a gearcase can ever gain. Get the gearcase out of the water. (Less drag)... Sharpen the skeg...
    Likes hydroyt liked this post

  2. #12
    Team Member fs5's Avatar
    Join Date
    Jun 2008
    Posts
    305
    Post Thanks / Like

    Default

    Hi mate you can get the gears lapped so they mesh together better . Haven’t heard about shimming tighter.
    Haven’t tried tranny fluid in mine yet haven’t been brave enough. They reckon if you do you should change it after a couple hours. But they say it works.
    Grinding reverse gear off helps , can also trim a bit off the bottom of your skeg. But it’s minimal gains.

  3. #13
    Team Member Roflhat's Avatar
    Join Date
    Jul 2011
    Location
    Scotland
    Posts
    280
    Post Thanks / Like

    Default

    I don't mean shimming it so the gears are too close together, just taking the tolerance closer to what it should be from factory.

    Hey Jake, lapping looks like the way to go thanks mate. Did consider removing the reverse function but the rules say it has to be able to reverse.
    cheers

Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

Similar Threads

  1. Will blueprinting a 50D Tohatsu result in a 10% performance gain??
    By Hounddog in forum T750, T850 Outboards and VP 75
    Replies: 9
    Last Post: 07-06-2015, 12:58 PM
  2. Small gearcase to large gearcase conversion
    By Kevodaniel in forum Technical Discussion
    Replies: 3
    Last Post: 07-01-2014, 03:55 AM
  3. #6 Gearcase
    By TABARARACING in forum Parts and Accessories
    Replies: 0
    Last Post: 01-30-2011, 09:44 PM
  4. OMC F1 gearcase
    By inshoreracing in forum Parts and Accessories
    Replies: 8
    Last Post: 05-17-2009, 10:09 AM
  5. SSM #6 gearcase
    By spn43 in forum Parts and Accessories
    Replies: 2
    Last Post: 01-04-2009, 06:12 PM

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •