yamaha or tohatsu?

[iwanajohnson]

Hey Andrew, did ya read my iwanatohatsu joke?

that's pretty funny, I just read that, lol. I think that the omc products are the only thing that sounds rite in my name, Iwanatohatsu just doesen't roll off your tongue as well.

[tthibodaux]

that's pretty funny, I just read that, lol. I think that the omc products are the only thing that sounds rite in my name, Iwanatohatsu just doesen't roll off your tongue as well.

[iwanajohnson]

so what I'm getting out of all of this great information is you can make any 3 holer run very well no matter what the brand it's all about what you prefer. it's just like any other brand, someone always likes the other one. I've got an omc and love omc, but eeevverryyoonnee around me also has an omc and I'd love to see their looks if I could take somethin else and beat em with it. so which 3 holer would be able to make the most tourque, including omc. tryin to make a fast 3 hole drag boat with an outboard jet, tough task, anyone got an answer...

[Fast Fred]

a MOD or Super Mod56 would be hard to get around.

this is a Super Mod56
this is a Mod56

on a jet it's all about the low end, the impellor stalls about6100rpms for the most part, just can't move much water after that

[Fast Fred]

?, Stall, like an airplane prop, after about 3000rpm's of prop or jet impellor speed, they can not move more water, or air for the airplane, so it "Stalls".

it's runnin, it's turnin, and the rig is slowin down
you good this far?

remeber what the rules are on Mods, NONE, thare no rules

[iwanajohnson]

?

remeber what the rules are on Mods, NONE, thare no rules

I love that saying rite there!!! Thomas not makin fun of ya and not makin fun of fred either but I'm lovin this translation stuff. haha. is the diff. on the mod 56 and the super mod56 the front half or lenght of rods?

[Roy Hodges]

a MOD or Super Mod56 would be hard to get around.

this is a Super Mod56
this is a Mod56

on a jet it's all about the low end, the impellor stalls about6100rpms for the most part, just can't move much water after that

......................................
SO, cubic inches (or C.C.'s) RULE . Cubes rule ! Low end is ruled by more , & Most cubic inches , get a big block 3 holer . a 90 horse merc or 90suzuki or 90 yamaha or 90 Tohatsu - by now you (should ) get the point . Only thing better than cubic inches is cubic FEET !- cubic Dollars helps a lot , also

[Fast Fred]

i know a guy with a 3cyl drag boat, a river racer, and on any given day on that river, there are no rules on any thing what so ever. my $$$$ is on Himall day
OMC tripple

[iwanajohnson]

i know a guy with a 3cyl drag boat, a river racer, and on any given day on that river, there are no rules on any thing what so ever. my $$$$ is on Himall day
OMC tripple

same thing I'm doin river racin, no rules, so hopefully that's my motor. I like that saying to cubic dollars, haha.

[iwanajohnson]

alrighth eres another question, I need an explination of ports and porting, for example on a square port motor, do ya make prts higher or wider to get different types of power out of them, that kinda stuff neone here go any basic explinations of that kinda stuff?