just curious to know,
izzit applied to all outboard engine of yammie,
just curious to know,
izzit applied to all outboard engine of yammie,
Last edited by quty06; 11-24-2008 at 09:03 PM. Reason: add questions
i only know of one yamaha moda that comes outa the box with no limiter. but you can disconnect the rest of them.
Thanks for the respon,
i'm goin to ask u a question, is there special wire colour to disconnect for? izzit same colour for all the motor. i'm still green about this all.
white wire, comes out of the box and makes a loop and goes back in, on the older style 40-50hp thares a tang on the back of the box just move it over to off, as in revlimiter off
this is ON rite..
screw the other site or remove at all to off Rev Limiter?
yes, move it over. them screws can be real tight, can be best to grab them with a set of grips to brake them loose.
thanks FF, for fast reply
Mine is 40hp 3cyl yammie (1988) outboard,
My Q is How to advance the timing? by mag or flywheel or any other way?
but with ""hitachi"" CDI
the screw on the bottom of the seesaw controls the max advance.
find TDC and line up the pointer first.
seesaw= the arm hooked to the mag plate, with the two screws in it, top screw controls the low side or pickup timin.
There are currently 1 users browsing this thread. (0 members and 1 guests)
Bookmarks