Fast fred do u have a straight in front for sale
?. Ill send you them photos today of the portin of my engine
I asked earilier in thread but got no reply about the straight front
Fast fred do u have a straight in front for sale
?. Ill send you them photos today of the portin of my engine
I asked earilier in thread but got no reply about the straight front
Who aint addicted to fast boats.....
thinkin a pro 50 yamaha braket works, yes it will. did buy new 15" 70hp mids from Hydrotec,may be a used one to be had, 300 buck was a long time ago, like 10years.
i do have a straight moda, but she is not for sale, did see them pics, is there a stamped coin in the top of the moda?
Part one of "Secrets of the OMC Mod 50" : http://www.boatracingfacts.com/forums/showthread.php?t=2052
Who aint addicted to fast boats.....
Well Calhoun Marine is only doing Mercury outboards at this time. Still on the look out for someone that can cut a Yamaha 70 hp mid down to a 15". I have a 20" mid section with a F50 4-stroke lower unit also 20" that will need to be cut down. Using a Pro50 tilt trim unit. Building on a powerhead at the moment.
Fast Fred what about some FT pistons and rods .would you have any/know where I can acquire them?
Who aint addicted to fast boats.....
seaway would have new rods and one ring pistons.
a short shaft 70hp yamaha bolts right up to a pro50 braket
Part one of "Secrets of the OMC Mod 50" : http://www.boatracingfacts.com/forums/showthread.php?t=2052
Hey Fast Fred, is the long shaft pro 50 bracket longer or different than a short shaft? If so, what is the mod you have to perform to make it fit on a Stinger?
Mike
There are currently 2 users browsing this thread. (0 members and 2 guests)
Bookmarks