I'm going to do a thread split
I'm going to do a thread split
Since 1925, about 150 different racing outboards have been made.
hec class is cheep... im'e unemployed and doing it,,,.. go figg.hehehehe
It's amazing how a little thing like attitude can make such a big difference in life...... Keep it up, Cheney!
when I have an alltitude my wife says 're jet'!
Can anybody tell me the ups and downs abt the hustler 3 into 1 exhaust?
Thats what i have now. Good/Bad? Im i wasting my time?
The three into one is a good exhaust. I am not sure what is done internally to Ralph Cooks engine, but he claims it is pretty much stock (don't we all), and he ran one with a short megaphone. At that time it was the fastest SEH in the country, bar none. he walked past m elike I was tied to a fence post at the Nationals. If I had that engine and set up and prop and boat he ran that day, I am betting I could compete up front with any 850CCMH or SEH in the country.
So given that information, you have to decide if you trust theroy or reality. If I were you I would give Ralph a call. He lives in Mississippi.
I couldn't recall if it was a short megaphone or just the elbow. By looks it is pretty much identical to the Hustler. So I think the system works. And yes, Ralph can drive now and again... hehehehehehehe. He has kicked my butt enough times I can prolly tell you what spark plugs he is using. I sure have seen the back of him a lot. Funny thing is though, it ain't no prettier ! hehehehehe.
Hey davidlL6 who did you say built that motor that i got from ya?
anyone experiance on the 3 holer v-rude when you mill the head/up comp... that it doesnt seem to like the same timeing ie about 19-22deg??? or maybe my starter getting tired already... seems i have to back off on timeing to let my my starter kick it over..on my kawi-rude???... just to let you guys know,,, kawi-rude project going very very very well so far.....that a very for every digit saw on gps last week testing,,,
And there were some that doubted me if what you did would work.... I guess if I am gonna run APBA this year, I better get on the ball and build some really cool project motors.
I have not experienced anything like you claim on milling the head. I think it has something to do with something else done. What compression are you pushing ? Be careful, there is a limit on how high you can go before you begin blowing plugs out the hole, and we all know how nice and fun it is to helicoil those.
There are currently 11 users browsing this thread. (0 members and 11 guests)
Bookmarks