More domes, had to go to the lathe to hold tolerances close!Originally Posted by OUTBOARDER
Can't wait to get these on the water and running
Thanks: 0
Likes: 0
Session #9 More Domes
More domes, had to go to the lathe to hold tolerances close!
Can't wait to get these on the water and running
On The Test Wheel Next Week
Well it will be test wheel soon and will see what it is.
Until then I will have to wait..................
Test #1 Positive : picked up 550 rpms
Test #1
Jetted way rich and pulled 3 deg of timing out
Still picked up 550 rpm over "modified" stock headwith CC's between the two very close!
Test #2
TBA
Thanks for watching
When R U going 2 B Selling them?
in OMC 56 cuber.Jackson When R U going 2 B Selling them?
17 Hours Ago 11:48 AM
Part one of "Secrets of the OMC Mod 50" : http://www.boatracingfacts.com/forums/showthread.php?t=2052
Capt'n It's as fast as I dare!!!
I will start 56ci on Saturday!
I guess yall want more compression!!!
Will get going on this and put up pics!!!
Anthony
Will have to hurry I start school again in the summer and OT at real job
ide be interested in heads for the 49.9 3" bore /850 /form-e class....dont know if possible to o-ring them??...cheyney
when testing is completed
I want to finish up testing and look at it one more time!!!
What engine did you have in mind?
Anthony
Yes O-rings are available
Yes can o-ring head if you do not want to use a head gasket.
When do you need it?
email modifiedoutboard@hotmail
Thanks,
Anthony
similiar to the 56 cuber but the 3" bore ..head bolt pattern different,,, the 70 hp evinrude we all run in form-e/850 hydro...
There are currently 1 users browsing this thread. (0 members and 1 guests)
Posting Permissions
Reply With Quote
Bookmarks