I bought a 45 from Dave Shillig out of Oriville CA and the kill switch will not shut off the engine.
The switch and wires check out. Not sure if it is wired right or not. Can someone tell me where the wires should hook up?
Thanks
Jeff Kelly
I bought a 45 from Dave Shillig out of Oriville CA and the kill switch will not shut off the engine.
The switch and wires check out. Not sure if it is wired right or not. Can someone tell me where the wires should hook up?
Thanks
Jeff Kelly
Jeff,
If you want to run up the hill and look at our motors you are more than welcome to. Just let me know.
Jason
jasondiamond@comcast.net
The wiring is way different then any OMC 15 I have.
Don't want to take any chances of burning up anything.
I need the DUNK test before I can drive at Eatonville.
I may head over to Gowins???
Thanks Guys
Jeff
black wire with yellow stripe coming out of the power pack goes to one side of the switch and the other side of the switch gets grounded to the motor usually on the screw that holds the wire terminal block to the motor.
All you are doing is completing a circuit to ground to kill the motor.
There are currently 1 users browsing this thread. (0 members and 1 guests)
Bookmarks