I just finished my new lightweight homemade craft and it weighs about 180lbs! The motor is a 30hp mercury! My prop is a 18p Merc chopper 2! Before, on my last boat which was a lot heavier but same design, my propshaft was 90mm below the bottom of the boat! Everybody would tell me to bring my motor up until the propshaft was level to the bottom of the boat! So this year I built a higher transom to do so! I added 5 inches of setback as well! The new boat has a tunnel and the propshaft is level with the bottom of the boat, not the tunnel! My motor sounds great and a lot less of my running surface is on the water on full plane BUT my speeds are slower than before on a much heavier boat! Is it possible that now the prop is slipping more and not getting the proper thrust? I feel like I want to lower the motor but I hate to cut the new transom! Please help!