is it worth while cutting the tuner on a 59ci merc 55hp?
my motors pretty stock ,it has chris carson reeds and the reed blocks been polished ,also i have drilled a couple 1inch holes in the gearbox.
i usually only rev it around 5500/6000 rpm.
is it worth while cutting the tuner on a 59ci merc 55hp?
my motors pretty stock ,it has chris carson reeds and the reed blocks been polished ,also i have drilled a couple 1inch holes in the gearbox.
i usually only rev it around 5500/6000 rpm.
I have been told that not really any gain there on that motor, for the amount of trouble to get to it. And in most cases you will loose bottom end power.
Lets sit back and see if thats correct................
Helping folks out around the globe.
Sounds good don't do much maby dry out a bit faster don't affect bottom end unless you enlarge the opening at the very top
shutup and drive it !!
Cut it, if it don't work put a stock one back in it. That's the best way to find out the truth!!!
Foreman's Marine
Foreman's Marine
thanks for the replies,i reckon 'i'l give it a go then.
nah mate ,hopefuly i'l have it done in the next month.
There are currently 1 users browsing this thread. (0 members and 1 guests)
Bookmarks