Fast Fred's Secrets of the OMC MOD50's Thread #1

[Fast Fred]

gots the 65hp flywheel on there, it's about 3lbs heavier than the Mod50 fly wheel, thinkin the Mod50 flywheel was on the FT power head too.

[Jeff Akers]

Nice work Fred, I bet your triger finger is start'n to itch

Have fun and be safe !

[Fast Fred]

thanks, yup took a long while, but lookin like the boat i was thinkin of when i started, gots to spin the gas can around, tryin to work out the fuel PSI
on the rail, at 6, thinkin i'm poppin the needels

talked to them guys that got that 70hp case,(i put a 75hp cut on it), said they had it at 7000 flyin the hull into the wind, nice , spinin a tricked out Ron Hill 4 blade, Jacked to the top on one of them thare F'n Fred Nitro nose cone setups , good stuff.

Kilo, spring kilo

[mr_velocity]

I bet is looks something like this

[Fast Fred]

nice boat, see about speedin up the drive shaft speed, say about a thousand
rpms. see what this looks like

[Boatnut]

Tidy Fred, Damn Tidy

[Fast Fred]

thanks, i likes it clean