New 25hp mono

[Damo]

Hi All
Just recently built my new 13' mono for our 25hp class here in OZ. It's full balsa core and hull weighs 56kg. Last race I finally cracked the 50mph mark with 51.6mph in my last race. Personaly I'm a tunnel man but our class forbids tilt and trim whils under way so the monos here run just as hard.
Cheers
Damien

[JohnsonM50]

Nice lookin boat Damo

[Skoontz]

Damo:

Do you have any plans for that boat? We are looking for one similar to a JT-250 boat.

BTW, nice looking ride!

[Damo]

Thanks guy's!
This was built from a female mould. The moulds are naw in Victoria (botom of Australia) The owner gets the boats profesionaly made naw buy a boat builder. Complette new hull they are $2700.00 AUD plus shipping or $3700.00 AUD plus shipping with all new race gear just add motor.
Thanks

BTW JT 250?is that one of the 250cc motors with pipes?

[JohnsonM50]

Being balsa core Im guessing its composite, not FG? Your getting some real good speed for 25 ponies!

[Skoontz]

Female mold? I did not thing molds had a sex! LOL...JT-250 runs in England. 15 HP motors. Their boats are wooden, I believe, have not seen one yet!....

[F-12]

Female mold..............Lay up INSIDE and get smooth finish outside. Male mold.............lay up outside and get smooth interior finish.

[RTM]

Skoontz
Of course molds have sexes. How do you think boat are born. the male mold gets together with the female mold, and you can figger out the rest.

Rich

[bajarick]

Sounds "moldy" to me