HI, I have a little problem.
On my racing engine, I use light flywheel, but today, the magnet for timing(not charging), is dead!!!
Have you a solution to change it.It seem it is the same like std flywheel...
thanks by advance
my boat....
HI, I have a little problem.
On my racing engine, I use light flywheel, but today, the magnet for timing(not charging), is dead!!!
Have you a solution to change it.It seem it is the same like std flywheel...
thanks by advance
my boat....
If you are talking about the "center" magnet I am not aware of any replacement on the market. You might ask over on Scream and Fly.com. The outer magnets can be changed with this kit though, BRP P/N 584304.
Are you sure that the "timing ring" on the center magnet hasn't just spun and is now out of time..?
I have been able to repair some that have done this.
PS: Nice boat !
Jeff 93-C
yes I am sure, it is bad center magnet:when i put a metalic spare near the center, nothing....like if there is no magnet...
the boat is a molinari.it is an italian boat,It is a boat to race at the 24 hours of Rouen...very very hard race....I use this boat with 6"middle section with f1gearcase.....if you have a solution for me....
I would suggest that you ask the same question here www.screamandfly.com
Sounds like you may need a new flywheel.
Good luck.
Jeff 93-C
What are the symptoms, we had the center magnets come off because they are glued on but I never had one go bad, do you have sensor output, will it not start, is it out of time, that is what a bad hub magnet will do, I may have a new hub for it, this is the flex flywheel or a 10amp, cast wheel?
hi,
when I put little metal spare, like a washer, it is not attract by the magnet...so not information to the trigger when the flywheel turn....
for the model, it is built with 3 parts, and I must use a little stator and another upper case..
if you want, I can send pics...
what do you thinks about that?
best regards
jm
Take a pic, but if the center hub is bolted in it is the flex wheel, I should have one, so you're saying it doesn't even start? You have no sensor output
there is the pic of the center of flywheel....
whta do you think?it is the same spare you have?
spek soon
jm
You still need a new one but put that one in a oven at 150 degrees for several hours. We limped along with one by doing that for a couple of races in the old days.
There are currently 1 users browsing this thread. (0 members and 1 guests)
Bookmarks