hOoTs
07-20-2010, 07:49 PM
The boat I bout has had turning problems on tight turns from day 1. RJ watched me race one heat race on Sat. In that race my boat skipped out on me in the turn, and getting passed up by other boats.Sun. morning RJ walk up to me and said "I don't like where your turn fin is" He said think about it. My turn fin was as far outside the sponson as you could get it. Long story short. He just happen to have an inspection plate. As I was pushing my boat to his pits Darrel happens to walk by RJ said Darrel who built the boat. Where can we cut into the sponson. He said right here. So RJ cuts a hole. We take the fin, and move it in. He brakes out a degree wheel, And said how about 3 degrees. OK lol not having a clue. Sounds good.
It was like night and day. It went from getting passed to passing other boats through the turns.
PS Thank you RJ:):):)
It was like night and day. It went from getting passed to passing other boats through the turns.
PS Thank you RJ:):):)