OMC running rough and cutting out at high RPMS

[looseunit225]

hey guys check out these pictures i sustained this small issue on friday morning and i had to get the boat scruitneered on friday and race on sunday!

[jerry book]

I kinda hate to say it but I dont think that is a Better Racing Product

[John (Taylor) Gabrowski]

That would make a nice mural hanging in a frame from the shop wall! :)

[JohnsonM50]

hey guys check out these pictures i sustained this small issue on friday morning and i had to get the boat scruitneered on friday and race on sunday!
Wow,, you vented it. Looks to be some missing stuff tho.

[looseunit225]

in one form or another its all there i have alot of small bits hahahaha!

i didnt even hear it go BANG! bassicly it was running rough than i was comming up to the bank at idle and it just stopped and the conrod (the part still connected to the crank) got stuck on what was left of the sleave!

the block and front half and one head destroyed and will go in the bin i saved 5 rods and pistons, a crank and one cylinder head!

[looseunit225]

oh by the way the hole in the piston is because i drilled a hole in it so i could get a puller on it and pull it out from the head side of the block!