this is a 1976 omc 22ci purchased from outboard paradise, built by howie pickerell
Type: Posts; User: GheenoeRacer; Keyword(s):
this is a 1976 omc 22ci purchased from outboard paradise, built by howie pickerell
This is what its going on
Hello all,
Just acquired a labanco megaphone and filler block for omc 22 ci. Was wondering if anyone has ever used one and how they liked it, how it performed. Also if anyone has a little history...
I have a 1980 Johnson 35 hp with thru hub gearcase and it does not ship. Seems linkage to clutch dog is disconnected or broken. What tool do I need to remove carrier to inspect everything to...
Has anyone made a upper mount for a omc 15? Can a simple plate be used to connect the 4 bolts in the tower to the steering bracket? Ideas anyone? Pictures?
Hello all.
Just acquired a very clean 1972 Merc 200 20hp powerhead . It has the points ignition which I understand is unreliable and expensive. Just for the heck of it I pulled the flywheel and...
Upon further inspection the oil line going to the carburetor has some sort of check valve in the reed plate. Connecting to the intake cover may allow more oil to the bearings for the increased rpm...
That says it all doesn't it!
Hard to quantify, yes. But lost compression if any is still lost compression, especially since these motors lack it and I don't think there's anything that can be done about that, unfortunately. I...
Yes notice how it won't build compression till after that, even at high rpm I would think you still loose some
I think those lines are to pull oil to the bearings.
I was reading about merc 25 mods and they said these 2 holes under the exhaust plate are for compression release and should be plugged to raise...
I'm interested as well, so far I've cleaned and polished castings on the exhaust. Not sure if I want to dry up exhaust. What did you do during blueprinting? In the 10xs pics, the small oil line goes...
62488
Hello all.
I have a few questions about modding a 1998 mariner 15 hp, I have plans to buy the racing gearcase as soon as funds allow, I currently have the motor apart for cleaning polishing and...