Attached is a YouTube address to 1 of 4 dyno runs from last weekend on you tube. Numbers are out of order. #3 is pickling after run. #1 was clearing gas and oil from last run with a fouled plug as can be seen from the low torque number. Then 2 and 4 being final. Tried making graph of ECU output but screwed that up. Did push to 8500 RPM with torque numbers falling. Fuel map adjustments were good as no steam wheel adjustments were necessary. So, good enough for now. Just need to find someplace to run.



https://www.youtube.com/watch?v=V29bTrxFWjk

https://www.youtube.com/watch?v=nbn7bYZQuak

https://www.youtube.com/watch?v=SN_azY75vAY

https://www.youtube.com/watch?v=xvtP_HSonW8