When you check out the wires for the kill circuit make sure you move the harness around near where it enters the lower motor cover. In case a wire is broken from the engine turning back and forth.
When you check out the wires for the kill circuit make sure you move the harness around near where it enters the lower motor cover. In case a wire is broken from the engine turning back and forth.
I will do that. Some 10 or 15 years ago some wires were fixed where a rat had gotten into them. I'm betting I have a butsplice somehwere that is corroded or loose.
There is a break somewhere that I can’t reach. Going to pull a new wire. Ran through 6 or so full tanks this weekend. Boat runs great.
There are currently 2 users browsing this thread. (0 members and 2 guests)
Bookmarks