2021 Peterson Race Boat Design 850mod laydown

[bigkahuna]

Get ready for upcoming race season. Professionally built Mod850 14’ laydown hydro. Priced well under cost to build. Must sell due to health problems. Brand new rebuild Evinrude 70hp 49.7ci (105hp+) bored 30 over. Shaved head to .450 combustion chamber. Built by Tim Kurcz of Fort Worth Texas, Jon Peterson build boat, carbon fibre used throughout boat. A true race boat. Comes with 4 blade Dewald prop, new twin mechanical fuel pumps, no rev limit ignition box, new starter, Summit racing aluminum fuel cell with gauge. All top quality hardware used, Kevlar steering cables. Check out build list in the pictures. Rebuilt carbs and rubber turn downs.Custom mid Section with internal exhaust, custom Mercury outboard transom mounting clamps and adjustable trim setting. Tim Kurcz rebuilt SST45 gear foot, new bearings and seals. Dash mounted engine monitor. Only about 20 minutes run time on boat, then health issues arose. Comes with good condition trailer with boat and trailer registration and lots of spare parts too.
Located in Western Canada, just up from Seattle.
Will take $6200.00 US funds OBO (just motor is worth $9000.00+, built by a top Evinrude race motor builder) give me a reasonable offer. Thank you Rod

[kellytheaker]

[QUOTE=bigkahuna;159555]Get ready for upcoming race season. Professionally built Mod850 14’ laydown hydro. Priced well under cost to build. Must sell due to health problems. Brand new rebuild Evinrude 70hp 49.7ci (105hp+) bored 30 over. Shaved head to .450 combustion chamber. Built by Tim Kurcz of Fort Worth Texas, Jon Peterson build boat, carbon fibre used throughout boat. A true race boat. Comes with 4 blade Dewald prop, new twin mechanical fuel pumps, no rev limit ignition box, new starter, Summit racing aluminum fuel cell with gauge. All top quality hardware used, Kevlar steering cables. Check out build list in the pictures. Rebuilt carbs and rubber turn downs.Custom mid Section with internal exhaust, custom Mercury outboard transom mounting clamps and adjustable trim setting. Tim Kurcz rebuilt SST45 gear foot, new bearings and seals. Dash mounted engine monitor. Only about 20 minutes run time on boat, then health issues arose. Comes with good condition trailer with boat and trailer registration and lots of spare parts too.
Located in Western Canada, just up from Seattle.
Will take $6200.00 US funds OBO (just motor is worth $9000.00+, built by a top Evinrude race motor builder)

[kellytheaker]

Get ready for upcoming race season. Professionally built Mod850 14’ laydown hydro. Priced well under cost to build. Must sell due to health problems. Brand new rebuild Evinrude 70hp 49.7ci (105hp+) bored 30 over. Shaved head to .450 combustion chamber. Built by Tim Kurcz of Fort Worth Texas, Jon Peterson build boat, carbon fibre used throughout boat. A true race boat. Comes with 4 blade Dewald prop, new twin mechanical fuel pumps, no rev limit ignition box, new starter, Summit racing aluminum fuel cell with gauge. All top quality hardware used, Kevlar steering cables. Check out build list in the pictures. Rebuilt carbs and rubber turn downs.Custom mid Section with internal exhaust, custom Mercury outboard transom mounting clamps and adjustable trim setting. Tim Kurcz rebuilt SST45 gear foot, new bearings and seals. Dash mounted engine monitor. Only about 20 minutes run time on boat, then health issues arose. Comes with good condition trailer with boat and trailer registration and lots of spare parts too.
Located in Western Canada, just up from Seattle.
Will take $6200.00 US funds OBO (just motor is worth $9000.00+, built by a top Evinrude race motor builder) give me a reasonable offer. Thank you Rod

Sir -