Turned out nicely, but the LU appears to be too low in the water. With a cleaver you could try underside of prop hub on same level as and parallel to keel. Had good results with this as initial setting on Vee-bottomed hulls. Good luck!
Is the torpedo level with sponson bottom ?
Argo Cat 18 - Sold
Merc 2.4EFI/CLE - Sold
That "one" worked well didn't it
Helping folks out around the globe.
That looks like a realy good job done.
was this welded on ? and was the original water pick ups just filled with weld etc ?
realy does look very good and like an original race gearbox.
phill
Is it safe to use a jack plate on a cat ?
What's the speed differance in puting a cone n raising ?
And do a 13.5 cat like small diamiteres or large dia props?
Thanks tring to get in the cat world
There are currently 1 users browsing this thread. (0 members and 1 guests)
Bookmarks