[QUOTE=Tiller guy;147389]What about the auto lube linkage?[/QUOTE
The one that does the throttle? I have to resize the threaded rods and they will fit. Then I gotta find a way to make them connect on the engine
[QUOTE=Tiller guy;147389]What about the auto lube linkage?[/QUOTE
The one that does the throttle? I have to resize the threaded rods and they will fit. Then I gotta find a way to make them connect on the engine
I take it your motor is premix? The oil injected motors have a linkage arm on the other side of the carbs that controls the oil pump.
Yes premix, I think I found an easy solution, if it works I'll post it up in a day or so, fingers crossed
Ok. The fuel pump works after switching the bottom carb to the middle, the choke lines up after switching the rods that hold the choke butterflies on the bottom and middle carb. Just gotta play around with this linkage, i had a roller off an old tohatsu that almost worked perfectly straight up. Cant wait to get it sorted.
Just incase anyone reads this - i've fitted 40hp Tohatsu carbs, the 50hp carbs require more work and the pump doesnt line up
Any test results yet? I remember someone saying the stock yamaha link rod worked ok?
Get an old factory carb and used the roller and linkages. Very happy with the result, have full throttle after a bit of fiddling and will hopefilly run it this weekend. Still need to lengthen the the choke rod but thats a minor job, should run as it is.
Nice to see that the stock throttle link rod works. Good luck on testing! Keep us posted.
There are currently 1 users browsing this thread. (0 members and 1 guests)
Bookmarks