Need some more orders for pistons. Spread the word and contact me at Phil McDaniel 843-650-0400 home 843-446-7767 cell or rpms@sccoast.net
Thanks Phil
Need some more orders for pistons. Spread the word and contact me at Phil McDaniel 843-650-0400 home 843-446-7767 cell or rpms@sccoast.net
Thanks Phil
Need some more orders to make a run of pistons for 3 cyl. OMC's. Have half enough to order. Let me know as to the size and quantity needed. Phone #'s are in an earlier post. Thanks Phil McDaniel
Hey there Phil, im gonna need a set. thinking 0.20 over would be good
any pricing? im over here in aussie land so might even get like a set of 0.40's to put away
phil, sent you a pm atfer you replied.. can you reply so i know what the go is?
thanks mate
how much for a set of three pistons ,will you paypal? when will they be available. How much for rods new or used ? and wrist pin kits ?
Hey Scud, i know Phil doesnt get on here very much, he sent me the prices as i have ordered 2 sets.. i do know Pistons 100.00US each, rods are $80.00US each bearing kits are $20.00US Each...
Hope that helps..
not sure on paypal..
cheers
thanks, If I may ask, how fast is your yellow boat with sst60 ?how high is the motor jacked and what prop ?
hey there scud.shes no sst60.
814cc 70hp block, with some port work, 65hp dome top pistons, FT head to suit. later style carbs, 2stage plastic reeds, 2-1 gear bag, 12 x 23 cleaver with hub added.. shes good for 75mph
p.s. the centre of the gearbox is a few inches below bottom of boat.. really needs to come up a little.. but no one catches me so ill leave her how she is!
Last edited by 850cc racer; 07-24-2009 at 06:59 PM. Reason: added motor height.
Hey guys, Lost my sheet of paper as to who needs and wants to get in on the 3-cyl. OMC Mod. 50 type pistons. I have one man who may take enough to make an order. Help me out with your names and sizes/quantities again if you would. My phone #'s and info are a few post back. Thanks Phil
If I've contacted you by phone or e-mail in the last 24 you should be O.K.
There are currently 1 users browsing this thread. (0 members and 1 guests)
Bookmarks